SEN00945-00 50 Disassembly and assembly 3. Install engine front seal (16) from inside of seal carrier (14). a Set the height of the seal flush with the inside wall of the seal carrier. a Installed dimension from outside of seal carrier (14): 0.5 – 1 mm q Carry out the following installation in the reverse order to removal. [*1] 3 Air hose clamp: 10.5 ± 0.5 Nm {1.07 ± 0.05 kgm} 4. Apply pilot (P) to the crankshaft and push it and seal carrier (14) into the crankshaft with the hands. [*2] 3 Radiator hose clamp: 8.8 ± 0.5 Nm {0.9 ± 0.05 kgm] 5. Remove pilot (P). [*3] 3 Mounting bolt of crankshaft pulley and damper:
200 ± 10Nm {20.4 ± 1 kgm} q Refilling with coolant Add coolant through the coolant filler to the specified level. Run the engine to circulate the coolant through the system. Then, check the coolant level again. 5 Coolant: Approx. 39 l 6. Install seal carrier (14). 2 Flange surface: Gasket sealant (LG-7) q Tighten the mounting bolts in the order of [1] o [5] shown in the figure. 3 Seal carrier mounting bolt: 9.8 ± 2 Nm {1 ± 0.2 kgm} a Check the installed dimension of 0.5 – 1 mm. 7. Install dust seal (15). a Push in the dust seal until it reaches the oil seal. a Install the crankshaft pulley and damper temporarily and install the fan belt, and then tighten to the specified torque.
22 D65EX, PX, WX-15E0