50 Disassembly and assembly SEN00947-00 3) Using eyebolts [2], remove transmission case (11). a Hang the transmission case vertically by using a lever block. 4) Remove snap ring (21). 5) Drive out input shaft (22) from the torque converter side and remove front plate assembly (23). 5. Input shaft/Front plate/No. 1 carrier assembly 1) Remove remaining 3 tie bolts (12). 2) Using eyebolts [3], remove input shaft/ front plate/No. 1 carrier assembly (13). 6) Remove snap ring (24), then remove input shaft (22) by driving it out to the torque converter side. 7) Remove snap ring (25) and No. 1 ring gear (26).
8) Pull out shaft (27) and remove thrust washer (28), gear (29), bearing (30), and ball (31). a Take care not to lose ball (31). 6. Disassembly of Input shaft/Front plate/No. 1 carrier assembly 1) Remove snap ring (14), No. 2 sun gear (15), and snap ring (16). 2) Remove snap ring (17) and No. 1 sun gear (18). 3) Remove snap rings (19) and (20). D65EX, PX, WX-15E0 21