Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF TRQFLOW TRANSMISSION ASSEMBLY

SEN00947-00 50 Disassembly and assembly 4) Using 2 forcing screws [13], tighten No. 3 housing (83) and insert dowel pin in the housing securely. a Keep 2 forcing screws [13] installed until step 13. 5) Install bearing (74) to No. 3 planetary gear (73) and fit thrust washers (72) to both sides, then set them to the carrier. 6) Install ball (75) and shaft (71). 7) Install bearing (70) to No. 4 planetary gear (69) and fit thrust washers (68) to both sides, then set them to the carrier. 8) Install shaft (67), matching the pin hole of the shaft to the pin hole of the carrier. 9) Check that the pin holes are matched to each other and drive in pin (66). 10) Install seal ring (65).

a Before driving in pin (66), check that there are no burrs in the pin hole of carrier (64). If there is any burr, remove it with sandpaper, and then drive in pin (66). 12. Assembly of No. 3 and No. 4 carrier and output shaft assembly 1) Install inner race (82) to output shaft (78). 2) Install No. 5 sun gear (81) and snap rings (80) and (79). 3) Install No. 4 sun gear (77) and snap ring (76). 4) Press fit bearing (116) to No. 3 carrier and install snap ring (117). 30 D65EX, PX, WX-15E0