Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF TRQFLOW TRANSMISSION ASSEMBLY

50 Disassembly and assembly SEN00947-00 11) Set No. 3 and No. 4 carrier assemblies (64) to output shaft (78). 12) Set jig [14] on the inner race side of bear- ing (116) and tighten bolt [15] to press fit bearing (116) to output shaft (78). a Dimensions of tap hole: M10 x 1.5, Depth: 32 mm 14. No. 3 ring gear Install No. 3 ring gear (60). a Direct the notched side of the outside teeth down. 15. Guide pin Install guide pin (38). 13) Install snap ring (62). 16. No. 3 discs and plates Install discs (58) and plates (59) alternately in order from the bottom. a Discs: 4 pieces, Plates: 5 pieces 13. No. 3 and No. 4 carrier assemblies, output shaft assembly 1) Using eyebolts [7], install No.

3 and No. 4 carriers and output shaft assembly (61). 2) Remove 2 forcing screws [13]. 17. No. 2 housing and No. 2 carrier assembly 1) Press fit bearing (118) to No. 2 housing (46) and install snap ring (44). D65EX, PX, WX-15E0 31