Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF TRQFLOW TRANSMISSION ASSEMBLY

SEN00947-00 50 Disassembly and assembly 2) Set ring gear (56) to No. 2 carrier (45) and install snap ring (55). 8) Install No. 2 housing (46) to carrier assem- bly (45). a Press fit the inner race side of the housing bearing. 9) Install snap ring (44). 3) Install bearing (52) to gear (51) and fit thrust washers (50) to both sides, then set them to the carrier. 4) Install ball (53) and shaft (49). a After assembling 2 gear sets, install snap ring (42). 18. No. 2 housing and No. 2 carrier assembly 1) Using eyebolts [16], install No. 2 housing and No. 2 carrier assembly (43). 5) Install the seal ring to No. 2 housing. 6) Install No. 2 ring gear (48). 7) Install spacer (47).

a Install the spacer with the cut inside end directed to the carrier. 2) Clamp No. 2 housing with tie bolts (10) and a pipe [17] and push the dowel pin in the housing securely. 3) Push up output shaft (63) lightly from underside and install snap ring (42). 32 D65EX, PX, WX-15E0