Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF TRQFLOW TRANSMISSION ASSEMBLY

SEN00947-00 50 Disassembly and assembly 22. No. 1 housing assembly 1) Install the seal ring to the No. 1 housing and No. 1 piston. a When installing the seal ring, check the direction of the pressure receiving side. 2) Install No. 1 piston (36) to housing. 3) Using eyebolts [4], install No. 1 housing assembly (35), matching it to No. 2 piston. a Press the housing and hit the dowel pin. 3) Set No. 1 ring gear (26) to No. 1 carrier and install snap ring (25). 4) Press fit bearing (122) to input shaft (22). 5) Install snap rings (20) and (19) to the input shaft. 6) Install input shaft (22) to No. 1 carrier assembly (123), and then install snap ring (24). 23. Assembly of input shaft and No.

1 carrier assembly 1) Install bearing (30) to gear (29) and fit thrust washers (28) to both sides, then set them to the carrier. 2) Install ball (31) and shaft (27). 7) Install No. 1 sun gear (18). 34 D65EX, PX, WX-15E0