Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF HSS ASSEMBLY

50 Disassembly and assembly SEN00948-00 Assembly a After installing the bearing, drop engine oil onto its rotating parts and rotate it several turns. a Check that the clearance at the bear- ing end is 0.03 mm or less. 3) Install outer race (84) to cages (76) and (86). q Precautions for assembly a Clean the all parts and check them for dirt or damage before installing. a Drop engine oil onto the rotating parts of each bearing and rotate it several turns. a Coat the sliding parts with engine oil before installing. a Apply grease (G2-LI) to each piston seal ring and install it evenly with the pressure receiving side directed to the housing. 2 Rotary seal ring:

Fix each seal ring with grease (G2- LI) and install it very carefully not to catch it in the parts. a Check that the snap rings are fitted securely in the grooves. 4) Install seal ring (85) to bevel gear shaft (81). 1. Suction tube Install suction tube (55). 5) Insert bevel gear shaft (81) in bevel gear (79) slung at the center of the case from the right side of the machine. a Tighten mounting nut (80) temporarily in advance. 2. Bevel gear shaft and bevel gear assembly 1) Install bolt (83) to bevel gear shaft (82). 2) Heat bearing (78) with a bearing heater, etc. and install it to the right side of the bevel gear shaft by shrink fit.

a If the bearing temperature is raised too high, the hardness of the heat- treated part lowers. Accordingly, do not raise the bearing temperature more than 120єC. D65EX, PX, WX-15E0 9