Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF HSS ASSEMBLY

SEN00948-00 50 Disassembly and assembly 6) Heat bearing (78) with a bearing heater, etc. and install it to the left side of the bevel gear shaft by shrink fit. a If the bearing temperature is raised too high, the hardness of the heat- treated part lowers. Accordingly, do not raise the bearing temperature more than 120єC. a After installing the bearing, drop engine oil onto its rotating parts and rotate it several turns. a Check that the clearance at the bear- ing end is 0.03 mm or less. 9) Adjusting pre-load a Adjust the pre-load with the bevel pin- ion assembly removed. i) Rotate the bevel gear and shaft assem- bly several turns to fit the bearing.

ii) Install too E3 to the end of bevel gear shaft (81) and measure the rotation torque with a torque wrench E4 . q Standard rotation torque: 10.3 – 14.7 Nm {1.05 – 1.5 kgm} a If the rotation torque is lower than the standard value, reduce the quantity of shims (77) in step 7. If the former is higher, increase the latter. 7) Install cages (76) and (86) to bevel gear and shaft assembly (75). a Since both cages are different from each other, take care not to mistake them. a Install shims (77) of the thickness and quantity recorded when removed. 3. Bevel pinion assembly 1) Assembly of bevel pinion i) Using push tool, press fit bearing (106) to bevel pinion (102) and install spacer (108).

q Standard shim thickness: 1.5 mm q Varieties of shim thickness: 0.2 mm, 0.3 mm, 0.5 mm 3 Mounting bolt: 98.1 – 122.6 Nm {10 – 12.5 kgm} 8) Tighten the bevel gear mounting nut securely. a Place a plastic hammer, etc. between the bevel gear. 3 Mounting nut: 245 – 309 Nm {25 – 31.5 kgm} 10 D65EX, PX, WX-15E0