Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF HSS ASSEMBLY

50 Disassembly and assembly SEN00948-00 ii) Using the push tool, press fit outer races (105) and (107) to cage (103). iii) Place bevel pinion (102) on the press stand and set cage (103). vii) Install pin (100), plate (99), then tighten bolt (97). 3 Bolt: 11.8 – 14.7 Nm {1.2 – 1.5 kgm} iv) Press fit bearing (104) to cage (103) with the press. v) Secure the pinion with the press and tighten locknut (101) with tool E2 . 2) Using guide bolt [9], install shims (96) and bevel pinion assembly (95). a Install shims of the thickness and quantity recorded when removed. 2 Locknut: Liquefied adhesive (LT-2) q Standard shim thickness: 2 mm q Varieties of shim thickness: 0.2 mm, 0.3 mm, 1.0 mm 3 Locknut:

392 – 441 Nm {40 – 45 kgm} vi) After tightening the nut, return it until 1 of its pin holes (8 places) is matched to 1 of the pin holes of the pinion shaft (5 places). a Return the nut by 0 – 9°. a Tighten the nut, turning the cage. a After tightening the nut, check that the bevel pinion rotates smoothly. D65EX, PX, WX-15E0 11