SEN00948-00 50 Disassembly and assembly 4. Adjusting backlash and tooth contact 1) Adjusting backlash Apply the probe of dial gauge [13] to the tooth tip at the end of the bevel gear at right angles. Fix the bevel pinion and move the bevel gear forward and back- ward, and read the value at this time. a Standard backlash: 0.2 – 0.28 mm a Measure the backlash diagonally at 3 or more places. q When backlash is too large Decrease the thickness of the shim on the left side of the machine body and increase the thickness on the right side by the same quantity.
(Move the bevel gear in direction B .) q If the measured backlash is out of the standard range, adjust it according to the following procedure. 2) Adjusting tooth contact Testing i) Apply red lead thinly to the tooth sur- faces of the bevel gear and turn the bevel gear in the forward and reverse directions, then check the tooth con- tact pattern on the bevel gear. a Adjust the backlash by increasing or decreasing the thickness of both shims. Do not change the total thick- ness of both shims so that the pre- load will not change.
(If the thickness of the shim on one side is increased, decrease the thickness of the other side, and vice versa.) q When backlash is insufficient Decrease the thickness of the shim on the right side of the machine body and increase the thickness on the left side by the same quantity. (Move the bevel gear in direction A .) ii) The tooth contact must be as follows (The standard distance is measured from the tooth tip of the bevel pinion.) a) Center of tooth contact: 20 – 40% of face width (from small end) b) Width of tooth contact: 30 – 50% of face width c) Center of tooth contact: 35 – 65% of tooth depth (from bottom) d) Width of tooth contact:
60 – 80% of tooth depth Check that tooth tip A , bottom B , small end C , and large end D of the teeth do not have any strong tooth contact. 12 D65EX, PX, WX-15E0