Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF FINAL DRIVE ASSEMBLY

SEN00948-00 50 Disassembly and assembly 2. Output shaft Install output shaft (27). 3. Gear assembly 1) Install bearing (26) to gear (25). 4) Using eyebolts [7], install cover assembly (21) to case, then tighten mounting bolts. 2) Install thrust washer (35) to case. 3) Using eyebolts [9], install gear assembly (24). 5. Sprocket, hub assembly 1) Install outer race (18) to hub (13). 2) Using tool J3 , install floating seal (16). a Remove all oil and grease from the O-ring and O-ring contact surface, and dry before installing. a After installing the floating seal, check that the angle of the seal is less than 1 mm. 4. Cover assembly 1) Install spacer (20) to cover (36).

2) Using tool J4 , press fit bearing (19). a A press can be used instead of the puller. 3) Using tool J3 , install floating seal. a Remove all oil and grease from the O-ring and O-ring contact surface, and dry before installing. a After installing the floating seal, check that the angle of the seal is less than 1 mm. 26 D65EX, PX, WX-15E0