50 Disassembly and assembly SEN00948-00 3) Check that there is no dirt or dust on slid- ing surface of floating seal, then coat thinly with engine oil. 4) Using eyebolts [13], set sprocket and hub assembly (15) in cover. 8) Set holder (10) in position. a The bearings are set right, so there is no need to adjust them, but in order to check that there are no defective parts, measure the preload as fol- lows. i) With no preload given to the bearings, measure the rotating torque of the sprocket hub, and take this as (b) Nm {kgm}. a Measure the sliding resis- tance of the floating seal first. ii) Rotate the sprocket and tighten the plate holder bolt to 245.2 – 308.9 Nm {25 – 31.5 kgm}.
iii) After tightening the bolt, check that the rotating torque is (b) + 0 to 61.8 Nm {0 to 6.3 kgm}. 5) Using tool J4 , rotate sprocket and hub assembly, and press fit bearing (19). a Press fit to a point which does not give any preload. 6. Shaft Using eyebolts [4], install shaft (9). 7. Carrier assembly 1) Press fit outer race (8) to planetary gear (5). a The bearing is set right, so be careful not to change the combination when installing. 6) Set hub (13) to ring gear (14), and install snap ring (12). 7) Using eyebolts [5], install ring gear and hub assembly (11). D65EX, PX, WX-15E0 27