IN CASE OF EMERGENCY 311 2. Place the gear selector into PARK. On four-wheel drive vehicles, shift the transfer case to the 4WD Low position. J ACKING I NSTRUCTIONS 4500 A ND 5500 S ERIES WARNING! If working on or near a roadway, be extremely careful of motor traffic. 3. Turn on the Hazard Warning Flashers. 4. Apply the parking brake. WARNING! To assure that spare tires, flat or inflated, are securely stowed, spares must be stowed with the valve stem facing the ground. 5. Turn the ignition OFF. Carefully follow these tire changing warnings to help prevent personal injury or damage to your vehicle: 6. Block both front and rear of the wheel diagonally opposite of the jacking position.
For example, if the driver’s front wheel is being changed, block the passenger’s rear wheel. Always park on a firm, level surface as far from the edge of the roadway as possible before raising the vehicle. Turn on the Hazard Warning Flashers. Apply the parking brake firmly and set the transmission in PARK. Block the wheel diagonally opposite the wheel to be raised. Never start or run the engine with the vehicle on a jack. Jack Warning Label 7 Do not let anyone sit in the vehicle when it is on a jack. CAUTION! Wheel Blocked Example Do not get under the vehicle when it is on a jack. If you need to get under a raised vehicle, take it to a service center where it can be raised on a lift.
Do not attempt to raise the vehicle by jacking on locations other than those indicated in the Jacking Instructions for this vehicle. NOTE: Passengers should not remain in the vehicle when the vehicle is being jacked. Only use the jack in the positions indicated and for lifting this vehicle during a tire change. (Continued)