FCA 2022 Chassis Cab — Jacking Instructions 4500 And 5500 Series

312 IN CASE OF EMERGENCY 1. If equipped, remove the spare wheel and tools from storage. two-piece assembly with a flat face. Lightly tighten the nuts. To avoid risk of forcing the vehicle off the jack, do not fully tighten the nuts until the vehicle has been lowered. 2. Using the lug wrench, loosen, but do not remove, the lug nuts by turning them counter­ clockwise one turn while the wheel is still on the ground. 6. Using the lug wrench, finish tightening the nuts using a crisscross pattern Ъ ­page­392. If in doubt about the correct tightness, have them checked with a torque wrench by an authorized dealer or at a service station. 3.

When changing the front wheel, place the jack under the axle as close to the tire as possible. Rear Jacking Location WARNING!­ Before raising the wheel off the ground, make sure that the jack will not damage surrounding truck parts and adjust the jack position as re­ quired. A loose tire or jack thrown forward in a collision or hard stop, could endanger the occupants of the vehicle. Always stow the jack parts and the spare tire in the places provided. 4. Raise the vehicle until the wheel just clears the surface. 7. Install wheel center cap (if equipped) and remove wheel blocks. Do not install chrome or aluminum wheel center caps on the spare wheel. This may result in cap damage.

WARNING!­ When changing a rear wheel, securely place the jack under the sway bar bracket (unless both tires are flat on one side, then place jack under shock bracket) facing forward in vehicle. Front Jacking Locations Raising the vehicle higher than necessary can make the vehicle less stable. It could slip off the jack and hurt someone near it. Raise the vehicle only enough to remove the tire. 8. Lower the jack to its fully closed position. Stow the replaced tire and tools as previously described. 9. Adjust the tire pressure when possible. 5. Remove the lug nuts and pull the wheel off.

For Single Rear-Wheel (SRW) models, Install the spare wheel and lug nuts with the cone shaped end of the nuts toward the wheel. For Dual Rear-Wheel (DRW) models, the lug nuts are a 10. After 25­miles (40­km), check the lug nut torque Ъ ­page­392 with a torque wrench to ensure that all lug nuts are properly seated against the wheel.