FCA 2022 Chassis Cab — Underbody Mounted Fuel Filter Replacement

344 SERVICING AND MAINTENANCE E NGINE M OUNTED F UEL F ILTER R EPLACEMENT CAUTION!­ 8. Install new o-ring back into ring groove on the filter housing and lubricate with clean engine oil. Diesel fuel will damage blacktop paving surfaces. Drain the filter into an appropriate container. NOTE: Using a fuel filter that does not meet the manu­ 9. Remove new filter cartridge from plastic bag and install into housing. facturer's filtration and water separating requirements can severely impact fuel system life and reliability. Do not prefill the fuel filter when installing a new fuel filter. There is a possibility debris could be introduced into the fuel filter during this action.

It is best to install the filter dry and allow the in-tank lift pump to prime the fuel system. NOTE: Do not remove cartridge from bag until you reach this step in order to keep cartridge clean. 10. Push down on the cartridge to ensure it is properly seated. Do not pre-fill the filter housing with fuel. The engine mounted filter housing is equipped with a No-Filter-No-Run (NFNR) feature. Engine will not run if: a. No filter is installed. 1. Ensure engine is turned off. 11. Install lid onto housing and tighten to 22.5­ft lb (30.5­N.m). Do not overtighten the lid. b. Inferior/Non-approved filter is used. Use of OEM filter is required to ensure vehicle will run. 2.

Place drain pan under the fuel filter drain hose. 12. Prime the engine, then start the engine and confirm there are no leaks Ъ ­page­345. 3. Open the water drain valve a quarter turn counterclockwise and completely drain fuel and water into the approved container. U NDERBODY M OUNTED F UEL F ILTER R EPLACEMENT 4. Close the water drain valve. 5. Remove lid using a socket or strap wrench. Rotate counterclockwise for removal. Remove used o-ring and discard it. NOTE: 6. Remove the used filter cartridge from the housing and dispose of according to your local regulations.

Using a fuel filter that does not meet the manu­ facturer's filtration and water separating requirements can severely impact fuel system life and reliability. The underbody mounted filter housing will cause the engine not to run if there is no filter installed. 1 — Drain Valve Engine Mounted Fuel Filter Assembly 7. Wipe clean the sealing surfaces of the lid and housing.