FCA 2022 Chassis Cab — Priming If The Engine Has Run Out Of Fuel

SERVICING AND MAINTENANCE 345 3. Open the water drain valve one full turn counterclockwise and completely drain fuel and water into the approved container. 1. Add a substantial amount of fuel to the tank, approximately 2 to 5 gal (8L to 19L). 2. Three priming cycles must be completed. Turn ignition to the RUN position and wait approxi­ mately 30 seconds. This will activate the in tank fuel pump. Turn the ignition switch to the off position, and leave off for at least 30 sec- onds. Repeat this procedure three times before cranking the engine. 4. Close the water drain valve. 5. Remove lid using a socket or strap wrench. Rotate counterclockwise for removal. Remove used o-ring and discard it. 6.

Remove the used filter cartridge from the housing and dispose of according to your local regulations. Underbody Mounted Fuel Filter Assembly 3. Start the engine using the “Normal Starting” procedure Ъ ­page­108. 1 — Drain Valve 7. Wipe clean the sealing surfaces of the lid and housing. 4. Once the engine starts, allow the engine to idle for a minimum of 30 seconds. CAUTION!­ 8. Install new o-ring back into ring groove on the filter housing and lubricate with clean engine oil. CAUTION!­ Diesel fuel will damage blacktop paving surfaces. Drain the filter into an appropriate container. NOTE: Water In Fuel (WIF) sensor is re-usable.

Service kit comes with new o-ring for filter canister and WIF sensor. P RIMING I F T HE E NGINE H AS R UN O UT O F F UEL Do not engage the starter motor for more than 15 seconds at a time. Allow two minutes between the cranking intervals. Do not prefill the fuel filter when installing a new fuel filter. There is a possibility debris could be introduced into the fuel filter during this action. It is best to install the filter dry and allow the in-tank lift pump to prime the fuel system. NOTE: The engine may run rough until the air is forced from all the fuel lines. 8 WARNING!­ WARNING!­ 1. Ensure engine is turned off. Do not open the high pressure fuel system with the engine running.

Engine operation causes high fuel pressure. High pressure fuel spray can cause serious injury or death. Do not use alcohol or gasoline as a fuel blending agent. They can be unstable under certain conditions and be hazardous or explosive when mixed with diesel fuel. 2. Place drain pan under the fuel filter drain hose.