FCA 2022 Chassis Cab — Charge Air Cooler — Inter-Cooler

352 SERVICING AND MAINTENANCE WARNING! the proper level, it should be added to the coolant bottle. Do not overfill. Cooling System Notes sion protection of your engine which contains aluminum components. Do not use a pressure cap other than the one specified for your vehicle. Personal injury or engine damage may result. Make sure that the coolant expansion bottle overflow hoses are not kinked or obstructed. NOTE: When the vehicle is stopped after a few miles/kilo­ meters of operation, you may observe vapor coming from the front of the engine compartment.

This is normally a result of moisture from rain, snow, or high humidity accumulating on the radiator and being vaporized when the thermostat opens, allowing hot engine coolant (antifreeze) to enter the radiator. If an examination of your engine compartment shows no evidence of radiator or hose leaks, the vehicle may be safely driven. The vapor will soon dissipate. Keep the front of the radiator clean. If your vehicle is equipped with air conditioning, keep the front of the condenser clean. Disposal Of Used Coolant Used ethylene glycol-based coolant (antifreeze) is a regulated substance requiring proper disposal.

Check with your local authorities to determine the disposal rules for your community. To prevent ingestion by animals or children, do not store ethylene glycol-based coolant in open containers or allow it to remain in puddles on the ground, clean up any ground spills immediately. If ingested by a child or pet, seek emergency assistance immediately. Checking Coolant Level — 6.4L Engine Do not change the thermostat for Summer or Winter operation. If replacement is ever neces­ sary, install ONLY the correct type thermostat. Other designs may result in unsatisfactory engine cooling performance, poor gas mileage, and increased emissions.

C HARGE A IR C OOLER — I NTER -C OOLER Do not overfill the coolant expansion bottle. The charge air cooler is positioned below the radiator and the air conditioner condenser. Air enters the engine through the air cleaner and passes through the turbocharger, where it is pressurized. This pressurized air rapidly reaches high temperature. The air is then directed through a hose to the charge air cooler and through another hose to the intake manifold of the engine. The air entering the engine has been cooled by about 50° to 100°F (10° to 38°C). This cooling process enables more efficient burning of fuel resulting in fewer emissions.

Check the coolant freeze point in the radiator and in the coolant expansion bottle. If engine coolant (antifreeze) needs to be added, the contents of the coolant expansion bottle must also be protected against freezing. The level of the coolant in the pressurized coolant bottle should be between the “MIN” and “MAX” range on the bottle when the engine is cold. The radiator normally remains completely full, so there is no need to remove the cap unless checking for coolant freeze point or replacing engine coolant (antifreeze). Advise your service attendant of this. As long as the engine operating temperature is satisfactory, the coolant bottle need only be checked once a month.

When additional engine coolant is needed to maintain If frequent engine coolant additions are required, the cooling system should be pressure tested for leaks. Maintain engine coolant concentration at a minimum of 50% OAT coolant (conforming to MS.90032) and distilled water for proper corro­ To guarantee optimum performance of the system, keep the surfaces of the charge air cooler, condenser and radiator clean and free of debris.