SERVICING AND MAINTENANCE 351 drained, flushed, and refilled with fresh OAT coolant (conforming to MS.90032), by an autho rized dealer as soon as possible. Please review these recommendations for using Organic Additive Technology (OAT) engine coolant that meets the requirements of the manufacturer Material Standard MS.90032. When adding engine coolant: damage. If any coolant is needed to be added to the system, please contact a local authorized dealer. Do not use water alone or alcohol-based engine coolant products. Do not use additional rust inhibitors or anti-rust products, as they may not be compatible with the radiator engine coolant and may plug the radiator.
Mixing engine coolant types is not recom mended and can result in cooling system damage. If HOAT and OAT coolant are mixed in an emergency, have an authorized dealer drain, flush, and refill with OAT coolant (conforming to MS.90032) as soon as possible. Cooling System Pressure Cap We recommend using Mopar® Antifreeze/ Coolant 10 Year/150,000 Mile (240,000km) Formula OAT that meets the requirements of the manufacturer Material Standard MS.90032. This vehicle has not been designed for use with propylene glycol-based engine coolant. Use of propylene glycol-based engine coolant is not recommended.
Mix a minimum solution of 50% OAT engine coolant that meets the requirements of the manufacturer Material Standard MS.90032 and distilled water. Use higher concentrations (not to exceed 70%) if temperatures below −34°F (−37°C) are anticipated. Please contact an authorized dealer for assistance. The cap must be fully tightened to prevent loss of engine coolant (antifreeze), and to ensure that engine coolant will return to the radiator from the coolant expansion bottle/recovery tank (if equipped). Some vehicles require special tools to add coolant properly. Failure to fill these systems properly could lead to severe internal engine damage.
If any coolant is needed to be added to the system please contact an authorized dealer. Adding Coolant Use only high purity water such as distilled or deionized water when mixing the water/engine coolant solution. The use of lower quality water will reduce the amount of corrosion protection in the engine cooling system. The cap should be inspected and cleaned if there is any accumulation of foreign material on the sealing surfaces. Your vehicle has been built with an improved engine coolant (OAT coolant conforming to MS.90032) that allows extended maintenance intervals. This engine coolant (antifreeze) can be used up to ten years or 150,000miles (240,000km) before replacement.
To prevent reducing this extended maintenance period, it is important that you use the same engine coolant (OAT coolant conforming to MS.90032) throughout the life of your vehicle. WARNING! 8 NOTE: It is the owner's responsibility to maintain the proper level of protection against freezing according to the temperatures occurring in the area where the vehicle is operated. Do not open a hot engine cooling system. Never add engine coolant (antifreeze) when the engine is overheated. Do not loosen or remove the cap to cool an overheated engine. Heat causes pressure to build up in the cooling system.
To prevent scalding or injury, do not remove the pressure cap while the system is hot or under pressure. Some vehicles require special tools to add coolant properly. Failure to fill these systems properly could lead to severe internal engine (Continued)