FCA 2022 Chassis Cab — Fluid Level Check — 6-Speed Transmission

354 SERVICING AND MAINTENANCE CAUTION!­ Fluid Level Check — 6-Speed Transmission 6. Remove the dipstick, wipe it clean and reinsert it until seated. Do not use chemical flushes in your transmission as the chemicals can damage your transmission components. Such damage is not covered by the New Vehicle Limited Warranty. It is best to check the fluid level when the transmission is at normal operating temperature (158-176°F / 70-80°C). This normally occurs after at least 15­miles (25­km) of driving. At normal operating temperature the fluid cannot be held comfortably between the fingertips. You can read the transmission sump temperature in the instrument cluster screen Ъ ­page­81. 7.

Remove the dipstick again and note the fluid level on both sides. The fluid level reading is only valid if there is a solid coating of oil on both sides of the dipstick. Note that the holes in the dipstick will be full of fluid if the actual level is at or above the hole. The fluid level should be between the “HOT” (upper) reference holes on the dipstick at normal operating temperature. If the fluid level is low, add fluid through the dipstick tube to bring it to the proper level. Do not overfill. Use ONLY the specified fluid Ъ ­page­401.

After adding any quantity of oil through the dipstick tube, wait a minimum of two minutes for the oil to fully drain into the transmission before rechecking the fluid level. Fluid Level Check — 8-Speed Transmission The fluid level is preset at the factory and does not require adjustment under normal operating conditions. Routine fluid level checks are not required, therefore the transmission has no dipstick. An authorized dealer can check your transmission fluid level using special service tools. Use the following procedure to check the transmission fluid level properly: 1.

Monitor the transmission temperature using the instrument cluster display, and operate the vehicle as required to reach the normal operating temperature. If the transmission is not functioning properly, or the vehicle cannot be driven, see the Note and Caution below about checking the fluid level at colder temperatures. If you notice fluid leakage or transmission malfunction, visit an authorized dealer immediately to have the transmission fluid level checked. Operating the vehicle with an improper fluid level can cause severe transmission damage. NOTE:

If it is necessary to check the transmission below the operating temperature, the fluid level should be between the two “COLD” (lower) holes on the dipstick with the fluid at 60-70°F / 16-21°C. Only use the COLD region of the dipstick as a rough reference when setting the fluid level after a trans­ mission service or fluid change. Re-check the fluid level, and adjust as required, once the trans­ mission reaches normal operating temperature. CAUTION!­ 2. Park the vehicle on level ground. 3. Run the engine at normal idle speed for at least 60 seconds, and leave the engine running for the rest of this procedure. If a transmission fluid leak occurs, visit an authorized dealer immediately.

Severe transmission damage may occur. An authorized dealer has the proper tools to adjust the fluid level accurately. 4. Fully apply the parking brake, and press the brake pedal. 5. Place the gear selector momentarily into each gear position (allowing time for the transmission to fully engage in each position), ending with the transmission in PARK.