FCA 2022 Chassis Cab — Rear Axle And 4x4 Front Driving Axle Fluid Level

SERVICING AND MAINTENANCE 355 CAUTION!­ Fluid And Filter Changes — 8-Speed Transmission CAUTION!­ If the fluid temperature is below 50°F (10°C) it may not register on the dipstick. Do not add fluid until the temperature is elevated enough to produce an accurate reading. Run the engine at idle, in PARK, to warm the fluid. Under normal operating conditions, the fluid installed at the factory will provide satisfactory lubrication for the life of the vehicle.

Using a transmission fluid other than the manufacturer’s recommended fluid may cause deterioration in transmission shift quality and/or torque converter shudder, and (for 6-speed transmissions) will require more frequent fluid and filter changes Ъ ­page­401. Routine fluid and filter changes are not required. However, change the fluid and filter if the fluid becomes contaminated (with water, etc.), or if the transmission is disassembled for any reason. Fluid And Filter Changes — 6-Speed Transmission 8. Reinsert the dipstick. Check for leaks. Release the parking brake. R EAR A XLE A ND 4 X 4 F RONT D RIVING A XLE F LUID L EVEL NOTE:

If it is necessary to check the transmission below the operating temperature, the fluid level should be between the two COLD (lower) holes on the dipstick with the fluid at 68-86°F / 20-30°C. Only use the COLD region of the dipstick as a rough reference when setting the fluid level after a trans­ mission service or fluid change. Re-check the fluid level, and adjust as required, once the trans­ mission reaches normal operating temperature. For the proper maintenance intervals Ъ ­page­324. For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected.

If gear oil leakage is suspected inspect the fluid level. This inspection should be made with the vehicle in a level position. In addition, change the fluid and filters if the fluid becomes contaminated (with water, etc.), or if the transmission is disassembled for any reason. Selection Of Lubricant It is important to use the proper transmission fluid to ensure optimum transmission performance and life. Use only the manufacturer’s specified transmission fluid Ъ ­page­401. It is important to maintain the transmission fluid at the correct level using the recommended fluid. No chemical flushes should be used in any transmission; only the approved lubricant should be used.

When checking the fluid level, the vehicle should be in a level position. The fluid level at room temperature should be as follows: 8 If the fluid temperature is below 50°F (10°C) it may not register on the dipstick. Do not add fluid until the temperature is elevated enough to produce an accurate reading. Run the engine at idle, in PARK, to warm the fluid. CAUTION!­ 3500 Front Axle: ј inch ± ј inch (6.4­mm ± 6.4­mm) below the bottom of the fill hole. 3500 Rear Axle: ј inch ± ј inch (6.4­mm ± 6.4­mm) below the bottom of the fill hole. 4500/5500 Front Axle: ј inch +/- ј inch (6.4­mm ± 6.4­mm) below the bottom of the fill hole. 4500/5500 Rear Axle:

1/8­inch +/- 1/8­inch (3.2­mm +/- 3.2­mm) below the bottom of the fill hole.