FCA 2022 Chassis Cab — Base Quad: Low Beam Headlamp, High Beam Headlamp, Front Park And Turn — If Equipped

368 SERVICING AND MAINTENANCE Replacing Exterior Bulbs 4. Reach through the access hole of the wheel house splash shield and disengage the bulb access cover by rotating counterclockwise. 6. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the lamp. BASE QUAD: LOW BEAM HEADLAMP, HIGH BEAM HEADLAMP, FRONT PARK AND TURN — IF EQUIPPED 7. Pull the bulb straight out from the housing. 8. Reverse the procedure for installation of new bulb and covers. Low Beam See the following steps to replace: High Beam 1. Open the hood. See the following steps to replace: 2. Disconnect and isolate the negative battery cable. 1. Open the hood. 2.

Disconnect and isolate the negative battery cable. 3. Reach into the front wheel house ahead of the front wheel, remove the fastener, and lift the cover over the access hole in the front of the wheel house splash shield. Access to the rear of the lamp can be gained through this access hole. Bulb Access Cover 5. Disconnect the internal lamp wiring harness connector from the low beam bulb. CAUTION!­ Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. Bulb Access Cover Always use the correct bulb size and type for replacement.

An incorrect bulb size or type may overheat and cause damage to the lamp, the bulb socket, or the lamp wiring. 3. Look under the hood and behind the headlamp to find the high beam bulb access cover. Splash Shield Access Cover 4. Reach behind the headlamp and disengage the access cover by rotating counterclockwise.