SERVICING AND MAINTENANCE 369 5. Disconnect the internal lamp wiring harness connector from the high beam bulb. of the lamp can be gained through this access hole. 5. Pull the socket and bulb straight out from the housing. 6. Separate the bulb from the socket without twisting. Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. CAUTION! 7. Reverse the procedure for installation of new bulb and covers. Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the bulb socket, or the lamp wiring.
FOG LAMPS — IF EQUIPPED Halogen See the following steps to replace: Splash Shield Access Cover 1. Reach under and behind the front fascia/ bumper to access the back of the front fog lamp housing. 6. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the lamp. 4. Reach through the access hole of the wheel house splash shield and disengage the side marker socket by rotating counterclockwise a quarter turn. 2. Disconnect the fog lamp wiring harness connector from the fog lamp bulb. 7. Pull the bulb straight out from the housing. 8. Reverse the procedure for installation of new bulb and covers. Outer Park And Turn 8 See the following steps to replace: 1. Open the hood. 2.
Disconnect and isolate the negative battery cable. 3. Reach into the front wheel house ahead of the front wheel, remove the fastener, and lift the cover over the access hole in the front of the wheel house splash shield. Access to the rear Fog Lamp Bulb Park And Turn Sockets 3. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the housing.