370 SERVICING AND MAINTENANCE 4. Pull the bulb straight out from the housing. 2. Separate the connector holding the housing and wiring harness to the body. 5. Reverse the procedure for installation of bulbs and housing. 5. Reverse the procedure to install the bulb and cover. CAUTION! CAB TOP CLEARANCE LAMPS — IF EQUIPPED See the following steps to replace: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. 1. Remove the two screws from the top of the lamp. CENTER HIGH MOUNTED STOP LAMP (CHMSL) WITH CARGO LAMP See the following steps to replace: CHMSL Connector Location 1.
Remove the two screws holding the housing/ lens to the body as shown. 3. Turn the desired bulb socket a quarter turn and remove the socket and bulb from housing. 4. Pull the desired bulb straight from the socket. CAUTION! Removing Rear Screw From Clearance Lamp Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. Outside Bulbs: Cargo Lamps CHMSL Mounting Screw Locations Inside Bulb: Center High Mounted Stop Lamp