386 SERVICING AND MAINTENANCE WARNING! CAUTION! For the proper maintenance intervals Ъ page324. More frequent rotation is permissible if desired. The reasons for any rapid or unusual wear should be corrected prior to rotation being performed. Using tires of different size and type (M+S, Snow) between front and rear axles can cause unpredictable handling. You could lose control and have a collision. Do not drive for a prolonged period on dry pavement. Observe the traction device manufacturer’s instructions on the method of installation, operating speed, and conditions for use. Always use the suggested operating speed of the device manufacturer’s if it is less than 30mph (48km/h).
CAUTION! To avoid damage to your vehicle or tires, observe the following precautions: Do not use traction devices on a compact spare tire. Because of restricted traction device clear ance between tires and other suspension components, it is important that only traction devices in good condition are used. Broken devices can cause serious damage. Stop the vehicle immediately if noise occurs that could indicate device breakage. Remove the damaged parts of the device before further use. T IRE R OTATION R ECOMMENDATIONS Tire Rotation (Rearward Cross) Tires on the front and rear axles of vehicles operate at different loads and perform different steering, driving, and braking functions.
For these reasons, they wear at unequal rates. NOTE: On Canadian vehicles only, if your vehicle is equipped with All-Season type tires on the front and On/Off Road type tires mounted on the rear, do not use a front to back rotation pattern. Instead, rotate your tires side to side at the recommended intervals. Install device as tightly as possible and then retighten after driving about 0.5mile (0.8km). Autosock devices do not require retightening. These effects can be reduced by timely rotation of tires. The benefits of rotation are especially worthwhile with aggressive tread designs such as those on On/Off Road type tires.
Rotation will increase tread life, help to maintain mud, snow, and wet traction levels, and contribute to a smooth, quiet ride. Do not exceed 30mph (48km/h). Drive cautiously and avoid severe turns and large bumps, especially with a loaded vehicle. (Continued)