SERVICING AND MAINTENANCE 387 Dual Rear Wheels occurs when the vehicle ignition status is changed from Off to On and speeds of greater than 5mph (8km/h) are obtained and remain over 5mph (8km/h) for at about a 15minute period. You may need to drive for 20minutes to account slower speeds and stops. DEPARTMENT OF TRANSPORTATION UNIFORM TIRE QUALITY GRADES The following tire grading categories were established by the National Highway Traffic Safety Administration. The specific grade rating assigned by the tire's manufacturer in each category is shown on the sidewall of the tires on your vehicle.
All passenger vehicle tires must conform to Federal safety requirements in addition to these grades. T READWEAR If the tires are rotated incorrectly, the Auto local ization of the TPIS sensors will fail to locate correctly resulting in incorrect locations for the pressure values displayed in the Instrument Cluster. Tire Rotation CAUTION! The tires used on dual wheel assemblies should be matched for wear to prevent overloading one tire in a set. To check if tires are even, lay a straight edge across all four tires. The straight edge should touch all the tires. 4500/5500 Dual Rear Tires may only have one approved direction of rotation.
This is to accommodate the asymmetrical design (tread pattern) of the On/Off road tire. NOTE: If your vehicle is equipped with a Tire Pressure Information System (TPIS): When replacing a flat, the spare tire may have to be remounted on the rim or installed at a different location to maintain the correct placement of the tire on the wheel relative to the tire/wheel position on the vehicle. For example, if the spare is used to replace an outer rear tire it will have to be remounted on the rim so that the wheel is dished inward. That way the tread design of asymmetrical tires will maintain proper position.
The Treadwear grade is a comparative rating, based on the wear rate of the tire when tested under controlled conditions on a specified government test course. For example, a tire graded 150 would wear one and one-half times as well on the government course as a tire graded 100. The relative performance of tires depends upon the actual conditions of their use, however, and may depart significantly from the norm due to 8 The Tire Pressure Information System (TPIS) uses unique sensors in the inner rear wheels to help identify them from the outer rear wheels, because of this, the inner and outer wheel loca tions can’t be switched.
After a tire rotation is completed, as shown below, the system can auto learn the locations of each sensor ID. Auto learning/localization