390 SERVICING AND MAINTENANCE INTERIORS Do not use any harsh solvents or any other form of protectants on Stain Repel products. Seat Belt Maintenance P LASTIC A ND C OATED P ARTS S EATS A ND F ABRIC P ARTS Use Mopar® Total Clean to clean vinyl upholstery. Use Mopar® Total Clean to clean fabric upholstery and carpeting. Do not bleach, dye or clean the belts with chemical solvents or abrasive cleaners. This will weaken the fabric. CAUTION! WARNING! Direct contact of air fresheners, insect repel lents, suntan lotions, or hand sanitizers to the plastic, painted, or decorated surfaces of the interior may cause permanent damage. Wipe away immediately.
Do not use volatile solvents for cleaning purposes. Many are potentially flammable, and if used in closed areas they may cause respiratory harm. If the belts need cleaning, use a mild soap solution or lukewarm water. Do not remove the belts from the vehicle to wash them. Dry with a soft cloth. Sun damage can also weaken the fabric. Replace the belts if they appear frayed or worn or if the buckles do not work properly. Damage caused by these type of products may not be covered by your New Vehicle Limited Warranty. Stain Repel Fabric Cleaning Procedure — If Equipped Stain Repel seats may be cleaned in the following manner: NOTE:
If the belts retract slowly, inspect the upper turning loop for soiling. If soiling is present, clean with a wet soft cloth until all residue is removed. Cleaning Plastic Instrument Cluster Lenses Remove as much of the stain as possible by blotting with a clean, dry towel. WARNING! The lenses in front of the instruments in this vehicle are molded in clear plastic. When cleaning the lenses, care must be taken to avoid scratching the plastic. Blot any remaining stain with a clean, damp towel. A frayed or torn seat belt could rip apart in a collision and leave you with no protection. Inspect the seat belt system periodically, checking for cuts, frays, or loose parts.
Damaged parts must be replaced immediately. Do not disassemble or modify the seat belt system. If your vehicle is involved in a collision, or if you have questions regarding seat belt or retractor conditions, take your vehicle to an authorized FCA dealer or authorized FCA Certified Collision Care Program facility for inspection. For tough stains, apply Mopar® Total Clean, or a mild soap solution to a clean, damp cloth and remove stain. Use a fresh, damp towel to remove soap residue. Clean with a wet soft cloth. A mild soap solution may be used, but do not use high alcohol content or abrasive cleaners. If soap is used, wipe clean with a clean damp cloth. Dry with a soft cloth.
For grease stains, apply Mopar® Multi-Purpose Cleaner to a clean, damp cloth and remove stain. Use a fresh, damp towel to remove soap residue.