Electric System LEXION Montana 570-520 TIC Description of function: 1/2 CAN bus (Controller Area Network) Data exchange between electronic components via a serial network. BIF/CAB module (A10) The abbreviation BIF stands for the German "Bordinformator" (Fieldwork computer), the abbreviation CAB for CAN bridge. The essential machine data (serial no., operating hours, etc.) are stored in this module = BIF. At the same time, this module constitutes the interface between different CAN bus systems (CLAAS - Caterpillar - Daimler/Chrysler) = CAB.
Data storage All yield data is saved in the yield meter module (A21) whereas all other performance data is saved in the fieldwork computer / CAN bridge module (A10). It is therefore recommended to transmit these data prior to replacing a defective module, using the diagnosis system CDS. MONTANA control unit (axle and front attachment control system) - Measured value table CAN bus The MONTANA control system includes the axle control system and a front attachment control system complementing the CLAAS AUTO- CONTOUR system (CAC). The axle control system varies the height of the final drives of the rear axle.
For tilting the machine to one side, first the uphill side is lowered and then the downhill side is raised. The MONTANA front attachment control system allows varying the swing angle (cross levelling) and the cutting angle by adjusting the front attachment frame, in addition to the CAC functions. The electronic control of the MONTANA functions is via a separate CAN bus. The CAN data are converted in the axle control system adaptation module (A40) and made available to the CLAAS CAN bus system. According to the axle position, the value of the feed rake conveyor position sensor (B35) is offset in the AUTOCONTOUR module (CAC).
This allows working in hilly ground with the CAC function "Pre-set cutting height control" and area counting. 6s-4 Lex-e-06s 03/05 CAN high (U ) eff CAN low (U ) eff Diagnosis 1.9 ± 0.2 Volt 3.2 ± 0.2 Volt System OK approx. 2.5 Volt approx. 2.5 Volt Short-circuit CAN high / CAN low approx. 1.9 Volt > 3.2 Volt Short-circuit CAN high / +12 Volt approx. 2.5 Volt Short-circuit CAN high / Earth > 1.9 Volt approx. 3.2 Volt Short-circuit CAN low / +12 Volt approx. 3.2 Volt Short-circuit CAN low / Earth