CLAAS LEXION 500 series (520, 570) — Module A66 - GPS pilot module (GPB)

TIC LEXION Montana 570-520 Electric System Description of function: 2/2 AUTOCONTOUR (CAC) Settings for Montana machines The adaptation of the AUTOCONTOUR (CAC) and the axle control systems requires special settings for Montana machines. - Cutterbar spring setting The 5 mm cutterbar spring setting (see also Operator's Manual) must be made at a 50 % axle position. - Check of cutterbar spring setting Check setting dimension when travelling downhill with the axle cylinders fully extended. This dimension may be only - Learning the CAC limit stops The limit stops of the CAC sensors must be learned at a 75 % axle position.

While doing this, the cutting angle must be adjusted to the working position (cutterbar table surface in parallel with the ground). - CAC sensitivity The recommended CAC sensitivity for use with the grain cutterbar is 45 % with Montana machines. - Drop rate setting (front attachment) The drop rate must be adjusted with the machine at operating temperature and 50 % axle position. The drop rate is 5 – 6 seconds from the top to the bottom position. - Set value adjustment of CAC cutting height control When working in the field, the cutting height control set value (working within the sensor band range) should not be set higher than position 8. 03/05 Lex-e-06s 6s-5