Coordinates A8 AUTOCONTOUR module (CAC) ........................................ 2-i-20 A16 Reel controller module (HAS).............................................. 2-i-20 A27 VARIO module.....................................................................8-f-20 B3 AUTOCONTOUR sensing band sensor, left-hand (actual value)...................................................................... 8-d-26 B4 AUTOCONTOUR sensing band sensor, right-hand (actual value)....................................................................... 8-d10 B35 Feed rake conveyor position sensor (actual value)............ 6-h-16 B39 Reel height position sensor (actual value) .........................
7-e-10 B40 Reel horizontal position sensor (actual value) ...................7-e-10 B68 Cutterbar spring pre-tension sensor (actual value)............ 8-h-17 B70 VARIO cutting table position sensor (actual value)............. 8-f-21 S38c CAC cutting height control multifunction pushbutton switch for front attachment .................................................. 8-f-20 S38d CAC cutting height preselection multifunction pushbutton switch for front attachment .................................................. 8-f-20 X8 Ground speed control lever connector...............................4-h-17 X11 VARIO cutterbar sensors connector ...................................
7-f-22 XA Multifunction coupling A connector ..................................... 8-f-20 XB Multifunction coupling B connector ..................................... 8-f-20 XC Multifunction coupling C connector ..................................... 8-f-20 XV1 AUTOCONTOUR variant plug connector............................ 8-f-20 XV3 Reel functions variant plug connector ................................. 8-f-20 Circuit diagram 24a includes the complete sensor equipment required for the AUTO-CONTOUR system. The control of the individual functions is explained in the following circuit diagrams below:
20a - Front attachment raise/lower, cross levelling 21a - Reel adjustment - Standard cutterbar 21b - Reel adjustment - VARIO cutterbar 21c - Reel adjustment - Folding cutterbar 22a - Reel variable-speed drive Measured value table: Item Component Measured value Remark Sensor 12 V 0.25 V – 4.75 V (Pin 1-2) (Pin 1-3) 23a - Cutterbar table adjustment (Vario) B 3 B 4 B35 B39 B40 B68 B70 Key to diagram: Circuit diagram layout Electric System LEXION 500 TIC 24a-2 Lex-e-24a 24a AUTOCONTOUR (CAC) Item Component Measured value Remark B 3 B 4 B35 B39 B40 B68 B70 Sensor 12 V 0.25 V – 4.75 V (Pin 1-2) (Pin 1-3)