TIC LEXION Montana 570-520 Electric System Description of function: 1/2 Gearshift control Both the gearshift control switch (S90) and the shifting aid switch (S91) are supplied with power only if the signal of the ground speed control lever in neutral position (Z57) and of the applied parking brake (Z84/Z85) is applied to the gearshift control module (A36). When the shifting aid (S91) is actuated, the Montana master valve (Y128) is actuated via the gearshift control module (A36) – Circuit diagram 04s). In addition, the corresponding solenoid coil (Y121, Y122) loads the respective high-pressure circuit in the ground drive, making the hydraulic motor rotate slightly.
This allows shifting the 1 st gear (Y107) or the 2 nd gear (Y108) easily by hydraulic means. The gearbox switches (Z82, Z83) allow indicating the engaged gear in the operating panel (H60, H61) and this gear is kept in position (Y107, Y108) by the feedback to the gearshift control module (A36) even when the parking brake is released. Via the gearshift control module (A36), the gearbox switch 2 nd gear (Z83) also cuts the connection with the diesel engine speed adjustment (connection with A10) so that the road travel speed is automatically set.
If none of the mechanical gears (Z82, Z 83) is engaged, no control oil pressure for the ground drive is built up since the gearshift control module (A36) does not actuate the solenoid coil (Y125). Diesel engine speed adjustment - circuit diagram 2s The diesel engine speed depends on the position of switch S35 and of the 2 nd gear actual value switch (Z83). If full throttle speed is selected and the 2 nd gear engaged (signal input A36 / pin 4), the connection between (A10/Pin18) and (A10/Pin19) inside the Montana gearshift control module (A36) is cut (pins 10 and 11). The full throttle speed is reduced to road travel speed, depending on the country version.
Parking brake The parking brake (S93) is being actuated when solenoid coil (Y106) is not actuated. Besides the warning signals for insufficient brake oil pressure, the applied parking brake (S93/Z12) is also displayed in the terminal. If the parking brake (S93/Z12) is applied, no control oil pressure for the ground drive is built up since the gearshift control module (A36) does not actuate the solenoid coil (Y125). 03/05 Lex-e-42s 42s-3