Electric System LEXION Montana 570-520 TIC Description of function: 2/2 Service brake When activating the left (Z84) and the right (Z85) service brake, the control oil pressure in the ground drive will also collapse at the solenoid coil (Y125) and the variable-displacement pump will swing back to zero delivery, independent of the ground drive control lever position. Hydrostatic brake valve system When the diesel engine speed exceeds the allowed maximum of 2230 rpm (e.g. downhill travel), the ground drive hydraulic motor (HBM) brake restrictor module A45 also receives this information from the fieldwork computer module via the CAN bus.
Now the ground drive hydraulic motor (HBM) brake restrictor module A45 actuates the working hydraulics master valve (Y77) in order to put a greater load on the drive – Circuit diagram 4s. When the diesel engine speed exceeds 2300 rpm, the brake restrictor (Y124) is additionally actuated in order to restrict the high-pressure circuit in the ground drive. When the speed now drops below 2210 rpm, the brake restrictor (Y124) is deactivated. Swing angle of hydraulic motor and differential lock.
The hydraulic drive ranges resulting from the changed swivel angle in the hydraulic motor (S92, Y144) and the differential lock inside the axle (S94, Y105) are set manually without any influence from the gearshift control menu (A36). Montana brake pressure accumulator The sensor/switch (B90) controls the brake system accumulator pressure and, if necessary, actuates the working hydraulics master valve (Y77) via the gearshift control module (A36/pin16), the diode PCB D0 and the Ground drive hydraulic motor brake restrictor module (A45/pin5 pin2) in order to recharge the brake circuit accumulator – circuit diagram 04s. 42s-4 Lex-e-42s 03/05