CLAAS LEXION 500 series (520, 570) — 42t - Ground drive and brake control, Montana 570-520 - with integrated MONTANA control unit (from serial no. 581 00027 to 581 00037)

TIC LEXION Montana 570-520 Electric System Description of function: 1/2 Gearshift control The gearshift control switch (S90) is supplied with power only if the signal of the ground speed control lever in neutral position (Z57) and of the applied parking brake (Z84/Z85) is applied to the MONTANA GEN II module (A42). While shifting gears, the solenoid coils (Y121, Y122) are energized alternatingly at short intervals and the working hydraulics master valve (Y77) in parallel with them. The high-pressure circuits in the ground drive are subject to pressure alternatingly, which sets the hydraulic motor slightly in rotation in one or the other direction.

This makes engaging the gears in the gearbox (Y107, Y108) much easier. The engaged gear is displayed in the operating panel (H60, H61) via the gearbox switches (Z82, Z83). If none of the mechanical gears (Z82, Z 83) is engaged, no control oil pressure for the ground drive is built up since the MONTANA GEN II module (A42) does not actuate the solenoid coil (Y125). Diesel engine speed adjustment – circuit diagram 2t The diesel engine speed depends on the position of switch S35 and of the 2nd gear actual value switch (Z83). When full throttle speed is activated and 2 nd gear is engaged, the full throttle speed is reduced to road travel speed specifically for each country.

Swing angle of hydraulic motor and differential lock. The hydraulic drive ranges resulting from the changed swivel angle in the hydraulic motor (S92, Y144) and the differential lock inside the axle (S94, Y105) are set manually without any influence from the gearshift control menu (A36). 03/05 Lex-e-42t 42t-3