Komatsu — Status / Warning Indicator Light Symbols

Operator Cab And Controls - Section 32 OM3242 Page 32-24 A4. Cranking Motor Failure This amber indicator will illumi- nate when either starter motor (of two) fails to crank the engine, leaving just one cranking motor to start the engine. With only one cranking motor doing the work of two, the motor life will be shortened. If this indicator illuminates, truck operation may continue, but main- tenance personnel must be alerted as soon as possi- ble. D4. Retard Speed Control (RSC) Indicator This amber light is illuminated when the RSC switch mounted on the console is pulled out to the ON position. The light indi- cates the retarder is active.

It is for feedback only and does not signal a problem. This light will also illuminate if the cranking motors have been operational for more than 30 seconds at a time, or if seven attempts at starting for the full 30 seconds is reached. E4. Check Engine This amber check engine indica- tor will illuminate if a malfunction is detected by the engine elec- tronic control system. B4. Manual Backup Lights If this indicator illuminates, truck operation may continue, but maintenance personnel must be alerted as soon as possible. This amber indicator will illumi- nate when the manually oper- ated manual backup light switch (18, Figure 32-7) is turned ON. A5. No Power C4.

Engine Shutdown Timer This red “no retard/no propel” indicator light indicates a fault has occurred which has elimi- nated the retarding and propul- sion capability. A warning buzzer will also sound. When the key switch has been turned OFF, and certain condi- tions have been met, this indica- tor light will illuminate to indicate that the shutdown timing sequence has started. The engine could operate for up to three minutes. If this condition occurs, the operator must safely stop the truck, move selector switch to PARK, shutdown the engine, and notify maintenance personnel imme- diately. If the directional control lever is moved out of PARK, the engine will stop immediately.

If the key switch is turned back ON, the engine stop sequence will be terminated, and the engine will remain running.