Komatsu — Status / Warning Indicator Light Symbols

OM3242 Operator Cab And Controls - Section 32 Page 32-25 B5. Propulsion System Warn- ing E5. Battery Charging System Failure When this amber indicator is illuminated, the light indicates a “no propel” or “no retard” event may be about to occur. It is intended to provide advance notice of these events when possible. It does not require the operator to stop the truck, but may suggest that truck operation be appro- priately modified, in case a red alarm does occur. The red battery charging system light indicates a problem has been detected in the charging system, and system voltage is outside the normal operating range.

If this light illuminates, the operator must safely stop the truck, move selector switch to PARK, shut the engine off, and notify maintenance person- nel immediately. If truck operation continues, and the battery voltage drops below 20.0 volts, the propul- sion system will not operate, but retarding will still be available. C5. Propulsion System Tem- perature The following conditions will also illuminate this light: Battery voltage below 24.5V, engine rpm above 1450. Resets at 26V. This amber AC drive system temperature warning light indi- cates the drive system tempera- ture is above a certain level.

When this condition occurs, the operator must consider modifying truck operation in order to reduce system temperature. The operator is not required to stop the truck at this time. Battery voltage below 23V with engine off. Resets at 25.5V. Battery voltage above 32V with engine operating. Resets at 27.5V. A6. No Propel D5. System/Component Fail- ure The red “no propel” light indi- cates a fault has occurred which has eliminated the propulsion capability. If this condition occurs, the operator must safely stop the truck, move selector switch to PARK, shut down the engine, and notify maintenance personnel, immediately.

This red warning light indicates that the interface module system detected a failure somewhere on the truck. There are many condi- tions that could trigger the light to illuminate. If this light illuminates, the operator must safely stop the truck, move selector switch to PARK, shut the engine off, and notify maintenance personnel immediately. B6. Propel System @ Rest The amber “propel system @ rest” light is used to indicate that the AC drive system is de-ener- gized and propulsion is not avail- able. This light is activated when the instrument panel rest switch is turned ON and the AC drive system is de-ener- gized.

The three link energized lights (one on rear of the center console inside the operator cab, and two on the deck-mounted control cabinets) must NOT be illuminated at this time.