Komatsu — Interface Module

OM3242 Operator Cab And Controls - Section 32 Page 32-27 During normal truck operation, the red LED digits on the VHMS controller will count from 00-99 continu- ously. The Orbcomm controller (1, Figure 32-10) transmits data through antenna (1, Figure 32-11) mounted on top of the cab. The antenna coaxial cable is routed through the inside of the cab to protect it from dam- age. If the antenna or coaxial cable is damaged, replace the parts. When the key switch is turned OFF, the VHMS con- troller will remain on while it finishes processing inter- nal data and saves the recent data into permanent memory. When the data has been safely stored, the two digit LED display will turn OFF.

This process could take up to three minutes to complete. If 24V power is disconnected (using the battery disconnect switches) from the VHMS controller before it has completed it’s shut down proce- dure, the VHMS controller will lose all data gath- ered since the key switch was last turned ON. Do not disconnect battery power until the VHMS controller has completed the shut down proce- dure and has turned the LED digits off. FIGURE 32-11. ORBCOMM 1. Orbcomm Antenna 2. Magnetic Base Interface Module Interface module (3, Figure 32-10) receives data from the sensors installed on the truck and sends this information to the VHMS controller.

There is a small green LED light on the face of the controller. With the key switch ON, the light must be blinking. If the light is continuously illuminated, there is a problem in the controller. When a new interface module controller is installed on the truck, new software has to be installed inside the controller. IM-Diag connector (1, Figure 32-12) is used to connect the interface module to a laptop PC for installing software. FIGURE 32-10. VHMS COMPONENT LOCATION 1. Orbcomm Controller 2. VHMS Controller 3. Interface Module 4. Red LED Lights 5. Green LED Light