OM4048 1/08 Lubrication & Service - Section 40 Page 40-9 250 HOUR LUBRICATION AND MAINTENANCE CHECKS The 10 hour lubrication and maintenance checks should also be performed at this time. NOTE: “Lube Key” references are to the lubrication chart. 1. (CONTINUED NEXT PAGE) Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS ENGINE - Refer to the engine manufacturer’s Opera- tion & Maintenance manual for complete specifica- tions regarding engine lube oil specifications. NOTE:
If the engine is equipped with the *Centinel™ oil system and/or the Eliminator™ filter system, engine oil and filter change intervals are extended beyond 250 hours. Refer to engine Operation & Maintenance manual for specific oil and filter change intervals. * The Centinel™ system is a duty-cycle-dependent lubrication management system whereby oil is blended with the fuel and burned and an extension of oil change intervals can occur. a. Change engine oil. Lube Key “A”. b. Replace engine oil filters. NOTE: When installing spin-on filter elements, follow the instructions as specified by the filter manufacturer. The tightening instructions are normally printed on the outside of the filter.
Do not use a wrench or strap to tighten filter elements. c. If the truck is equipped with a reserve engine oil tank, change the reserve tank oil filter. d. Check belt tension and condition of each accessory belt. Refer to engine Operation & Maintenance manual for specific adjustment instructions. e. Check the torque on the cooling fan mounting cap screws (1, Figure 40-5). Tighten cap screws (2) to 237 N·m (175 ft lbs).