Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication & Service - Section 40 1/08 OM4048 Page 40-10 250 HOUR LUBRICATION AND MAINTENANCE (Continued) 2. 3. 4. 5. 6. 7. FIGURE 40-6. TASK COMMENTS CHECKED INITIALS COOLING SYSTEM - a. COOLANT MIXTURE - Check for proper coolant mixture. Add coolant as required. b. COOLANT FILTERS - Change coolant filters. c. COOLING SYSTEM HOSES - Check cooling system hoses for damage and signs of deteri- oration. Refer to the engine maintenance manual for coolant filter replacement instructions and proper coolant mix- ture instructions. FUEL FILTERS - Change the fuel filters (fuel separa- tors). Refer to engine Operation & Maintenance man- ual for specific filter replacement instructions.

FUEL TANK - Drain water and sediment from the fuel tank. Refer to Shop Manual, Section B, Fuel Tank - Cleaning. STEERING LINKAGE - Check the torque on pin retaining nuts (1, Figure 40-6) on the steering linkage - 712 N·m (525 ft lbs). Check the torque on tie rod retaining nuts (2) - 420 N·m (310 ft lbs). HYDRAULIC PUMP DRIVESHAFT & U-JOINTS - Add one or two applications of grease to each grease fitting. Non - moly grease only. Check that each bear- ing of the cross & bearing assembly is receiving grease. Replace bearings if any wear is detected. CAB AIR FILTER - Under normal operating condi- tions, clean every 250 hours. In extremely dusty con- ditions, service as frequently as required.

Clean the filter element with mild soap and water. Rinse com- pletely clean and air dry with a maximum of 275 kPa (40 psi). Reinstall the filter. Refer to Figure 40-4.