OM4048 1/08 Lubrication & Service - Section 40 Page 40-15 2500 HOUR MAINTENANCE CHECKS Maintenance for every 10, 250, & 500 hour Lubrication and Maintenance Checks should also be performed at this time. NOTE: “Lube Key” references are to the lubrication chart. 1. 2. 5000 HOUR MAINTENANCE CHECKS Maintenance for every 10, 250, 500 1,000 & 2,500 hour Lubrication and Maintenance Checks should also be per- formed at this time. NOTE: “Lube Key” references are to the lubrication chart. 1. 2.
Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS WHEEL MOTOR GEAR OIL - Wheel motor gear oil must be replaced every 2500 hours of operation. Refer to G.E. Motorized Wheel Service & Mainte- nance manual. FRONT WHEELS - Drain and refill with oil. Refer to Section G in this manual for detailed instructions on changing the oil. Lube key “E”. NOTE: Oil may need to be changed more frequently, depending on mine conditions and the results of the oil sample tests.
Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS AIR CLEANERS - Clean the Donaclone tubes in the pre-cleaner section of the air filter. Use low pressure cold water or low pressure air to clean the tubes. Refer to Section C, Air Cleaners. NOTE: Do not use a hot pressure washer or high pressure air to clean the tubes. Hot water/high pres- sure causes the pre-cleaner tubes to distort. FRONT WHEELS - If oil sampling is done every 500 hours - And the con- tamination trends are not rising, do not replace the wheel bearings.
Refer to Section G of the service manual for more detailed instructions on oil sampling. If oil samples are not taken - Drain oil and completely disassemble the front wheel bearings and check all parts for wear or damage. Refer to Section G of the service manual for disassembly and assembly proce- dures. Refill with oil. Check the oil level at the oil level plug on wheel hub. Lube key “E”.