Lubrication & Service - Section 40 1/08 OM4048 Page 40-14 1000 HOURS LUBRICATION AND MAINTENANCE CHECKS Maintenance for every 10, 250, & 500 hour Lubrication and Maintenance Checks should also be performed at this time. NOTE: “Lube Key” references are to the lubrication chart. 1. 2. 3. 4. 5. 6. 7. 8. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS HYDRAULIC TANK - Drain the hydraulic tank and clean the inlet strainer. Refill the tank with new oil; approximate capacity 901 l (238 gal). Use Lube Key “B”. NOTE:
Oil change interval can be extended to 2,500 hours if oil is sampled at every 250 hour intervals and no abnormalities are detected. RADIATOR - Clean the cooling system with a quality cleaning compound. Flush with water. Refill the sys- tem with anti-freeze and water solution. Check the Cooling System Recommendation Chart in this sec- tion for the correct mixture. Refer to the engine manu- facturer’s Operation and Maintenance Manual for the correct additive mixture. FUEL TANK - Remove the breather and clean in sol- vent. Dry with pressurized air and reinstall. OPERATOR'S SEAT - Apply grease to the slide rails. Lube Key “D”.
AUTOMATIC BRAKE APPLICATION - Ensure the brakes are automatically applied when brake pres- sure decreases below the specified limit. Refer to the appropriate Shop Manual, Section J, Brake Check- out Procedure. FRONT ENGINE MOUNT TRUNION - Add one or two applications of grease at fitting. Lube key “D”. AUTOMATIC LUBE SYSTEM PUMP - Check pump housing oil level. Refill to bottom of level plug with SAE 10W-30 motor oil. ELIMINATOR FILTER - Clean and check centrifuge. Refer to engine manufacture’s Operation & Mainte- nance Manual. (Service interval is dependent on duty cycle, oil quality, etc.)