Warnings And Cautions - Section 22 OM2222 Page 22-6 These danger plates are mounted on the outside of each frame rail to alert technicians to read the warn- ing labels attached to the side of each of the accumu- lators (see below) prior to releasing internal nitrogen pressure or disconnecting any hydraulic lines or hardware. There are similar decals mounted on top of each of the accumulators (both steering and brake) with the same danger message. This danger plate is attached to all four suspensions. The plate contains instructions for releasing internal pressure before disconnecting any hardware. Serious injury can occur if these directions are not followed.
A plate on the side of the hydraulic tank furnishes instructions for filling the hydraulic tank. Keep the system open to the atmosphere only as long as absolutely necessary to lessen the chances of system contamination. Service the tank with clean Type C-4 hydraulic oil. All oil being put into the hydraulic tank must be filtered using filters rated at three microns. A caution decal is attached below the hydraulic tank oil level sight gauge. Check level with body down, engine stopped, and key switch OFF. Add oil per fill- ing instructions, if oil level is below top of sight glass.