Komatsu — WARNINGS AND CAUTIONS

OM2222 Warnings And Cautions - Section 22 Page 22-7 A warning plate is attached to the hydraulic tank to inform technicians that high pressure hydraulic oil is present during operation. When it is necessary to open the hydraulic system, Ensure the engine is stopped and key switch is OFF to bleed down hydraulic pressure. There is always a chance of residual pressure being present. Open fittings slowly to allow all pressure to bleed off before removing any connections. Any operating fluid, such as hydraulic oil, escap- ing under pressure can have sufficient force to enter a person's body by penetrating the skin.

Serious injury and possibly death may result if proper medical treatment by a physician familiar with this injury is not received immediately. A wheel motor oil level decal is attached to the gear cover on both electric wheel motors. This decal stresses the fact that the truck must be on a level surface and parked for 20 minutes prior to checking the oil level. This is necessary in order to get an accurate reading. A decal plate located on the frame near the left hoist cylinder provides the operator or technician with the hook-up procedure for dumping a loaded, disabled truck. The use of a functional truck for hydraulic power is required.

Refer to the Section L for additional instructions for using this procedure. Warning decals are applied to both brake accumula- tors located inside the brake system cabinet behind the operator cab. These decals remind servicing technicians to close the accumulator drain valves after they have been opened to bleed brake pres- sure. It further warns not to over-tighten the drain valves to prevent damage to the valve seat(s).