Komatsu — WARNINGS AND CAUTIONS

Warnings And Cautions - Section 22 OM2222 Page 22-8 A warning plate alerts the technician to stop the engine, turn the key switch OFF, and open the drain valves on all three accumulators to bleed the hydrau- lic system pressure before disconnecting a brake line. A decal plate is located on the frame near the left hoist cylinder. It provides the operator or technician with the hydraulic hook-up procedure before towing a disabled truck, by using a functional truck for hydrau- lic power. This decal is located on the automatic lubrication res- ervoir informing the technician that the cover must never be removed for filling purposes as there is potential for dirt or debris entering the system.

Always fill the grease reservoir through the coupling provided where the grease passes through a filter before entering the reservoir. This warning decal is located below the battery dis- connect switches to warn personnel not to discon- nect the batteries during the first 90 seconds after turning the key switch off. Turn the key switch to the OFF position and wait for the engine to stop. After the engine has stopped, wait two minutes, and if no warning lights illuminate, then turn the battery disconnect switches to the OFF posi- tion. The first 90 seconds after the key switch is turned off is the bleeddown process.

Turning the battery dis- connect switches off within 90 seconds could inter- rupt the bleeddown process and leave stored energy in the accumulator. Wait two minutes after the engine has stopped, then observe for bleeddown malfunc- tion warning light in overhead panel. If warning is being displayed, notify maintenance immediately. Turning the battery disconnect switches to the OFF position sooner than two minutes could mask a prob- lem that was detected during the bleeddown pro- cess.