Komatsu — WARNINGS AND CAUTIONS

OM2222 Warnings And Cautions - Section 22 Page 22-9 This caution decal is placed near the battery discon- nect switches to alert servicing technicians that before doing any welding on the truck, always dis- connect the battery charging alternator lead wire before making any welding repairs. Turn the key switch to the OFF position and wait for the engine to stop. After the engine has stopped, wait two minutes, and if no warning lights illuminate, then turn the battery disconnect switches to the OFF posi- tion. Then disconnect the battery charging alternator lead wire.

Always fasten the welding machine ground (-) lead to the piece being welded; grounding clamp must be attached as near as possible to the weld area . Never allow welding current to pass through ball bearings, roller bearings, suspensions, or hydraulic cylinders. Always avoid laying welding cables over or near the vehicle electrical harnesses. Welding volt- age could be induced into the electrical harness and possibly cause damage to components. A high voltage danger plate is attached to the door of the rear hatch cover. High voltage may be present! Only authorized personnel can access this rear housing.

A caution decal is also attached to the door of the rear hatch cover to alert personnel that hot exhaust air is present and may cause injury. This caution decal is also placed around the retard- ing grid cabinet. These warning plates are mounted on all of the AC drive control housings and cabinets. High voltage may be present, with or without, the engine running! Only authorized personnel can access these cabi- nets.