Komatsu — WALK AROUND INSPECTION

OM3058 Operating Instructions - Section 30 Page 30-3 8. Move behind the front wheel and inspect the steering cylinder. Check for proper greasing and inspect the mounting hardware to ensure it is all in place. Inspect the suspension mounting hardware to ensure it is all in place. Ensure the suspension protective boot is in good condition. Inspect the hub and brakes for any unusual conditions. Check the entire area for leaks. 15. Open the rear hatch cover, turn on work light, if necessary. Inspect for leaks around wheel motor mounting to rear housing, and also brake hoses and fittings. Ensure that covers on wheel motor sump are in place, and that there are no rags or tools left behind.

Inspect condition of hatch cover gasket, report any bad gasket to maintenance. Turn off work light if used, close and latch hatch. 9. Inspect the sight glass on the hydraulic tank. With the engine stopped and body down, hydraulic fluid must be visible in the upper sight glass. 16. While standing in front of the rear hatch, look up to see that rear lights are in good condition, along with the back-up horns. Look up at the panhard rod to see that it is getting proper greasing. Also look at both body hinge pins for greasing and any abnormal condition. Check hoist limit switch and clear any mud/debris from contacts. 10.

Verify all hydraulic tank shut off valves are locked in their fully open positions. 11. Move around the hydraulic tank and in front of the rear dual tires. Inspect the hoist cylinder for any damage and leaks. Inspect both upper and lower hoist cylinder pins for integrity and for proper greasing. 17. Perform the same inspection on the right rear suspension as done on the left. 12. Before leaving this position, look under the lower edge of the chassis to ensure the flexible duct that carries the air from the blower to the final drive housing is in good condition with no holes or breakage.

Also, look up at the main hydraulic pumps to see that there is no leakage or any other unusual condition with the pumps or the pump drive shafts. 18. Move around the right dual tires. Inspect between the tires for rocks, and check the con- dition of the rock ejector. Inspect the tires for cuts or damage, and for correct inflation. 19. Perform the same inspection for wheel lugs/ wedges, wheel cover latches, and wheel leaks that was done on the left hand dual wheels. 20. Move in front of the right dual tires and inspect the hoist cylinder in the same manner as the left side. Check integrity and condition of the body- up limit switch. Remove any mud/dirt accumula- tion from the switch. 13.

Move around the dual tires, and check to see that all lugs/wedges are in place and tight. Inspect latches on the wheel cover to be sure they are properly latched. Inspect the wheel for any oil that would indicate brake leakage or wheel motor leakage. 21. Move around the fuel tank. Inspect the fuel sight gauge, (this must agree with the gauge in the cab). Inspect the attaching hardware for the fuel tank at the upper saddles, and then at the lower back of the tank for the security and condition of the mounts. Check the hoist filters for leaks. Check the dual tires for cuts, damage or bub- bles. Verify that inflation appears to be correct.

If the truck has operating on a flat tire, the tire must be cool before moving the truck inside a building. Check for any rocks that might be lodged between the dual tires. Inspect the rock ejector condition and straightness so that it can not damage a tire. 22. Move behind the right front wheel, and inspect the steering cylinder. Check for proper greasing and inspect the mounting hardware. Check the suspension mounting hardware and suspension extension. Ensure the suspension protective boot is in good condition. Inspect the hub and brakes for any unusual conditions. Check the entire area for leaks. 14. Inspect the left rear suspension for damage and for correct rod extension.

Check for leaks. Ensure that the covers over the chrome piston rod are in good condition. Inspect for proper greasing.