Komatsu — WALK AROUND INSPECTION

Operating Instructions - Section 30 OM3058 Page 30-4 23. Move around the right front wheel; check that all lugs/wedges are in place and tight. 30. When checking the coolant level in the radiator, use the coolant level sight gauge. If it is neces- sary to remove the radiator cap, relieve coolant pressure by depressing the pressure relief but- ton, and then slowly removing the radiator cap. 24. Move in behind the front of the right front wheel, check the hub and brakes for leaks and any unusual condition. Check the fuel filters for leaks. Inspect the steering cylinder for secure- ness and for proper greasing. Inspect the engine compartment for any leaks and unusual conditions.

Inspect the fan guard and belts. Check for any rags or debris behind the radia- tor. If the engine has been running, allow the coolant to cool before removing the fill cap or draining the radiator. Serious burns may result if skin comes in contact with hot coolant. 25. Inspect the auto lube system. Refer to Auto- matic Lubrication System in Section P, for spe- cific details concerning the auto lube system. 31. Inspect the covers over the retarding grids and ensure they are secure. Inspect the main air inlet to ensure it is clear. Ensure all cabinet door latches are secure. 26. Move around to the right front of the truck, drop the air cleaner pans and empty. 27.

While in front of the radiator, inspect for any debris in the radiator and remove. Check for any coolant leaks. Inspect headlights and fog lights. Inspect the battery box cover for damage and ensure it is in place and secure. 32. Move to the back of the cab. Open the doors to the brake cabinet and inspect for leaks. 33. Clean the cab windows and mirrors. Clean out the cab floor as necessary. Ensure steering wheel, controls and pedals are free of any oil, grease or mud. 28. Ensure the ground level engine shutdown but- ton is pulled up.

Inspect the fire control actuator to ensure the safety pin is in place and the plas- tic tie that prevents accidental actuation is in place and in good condition. Ensure the battery disconnect switches and propel lockout lever are ON. Always use grab rails and the ladder when mounting or dismounting the truck. Clean the ladder and hand rails of any foreign mate- rial, such as ice, snow, oil or mud. 34. Stow personal gear in the cab in a manner that does not interfere with truck operation. Dirt or trash buildup, specifically in the operator's cab, must be cleaned. DO NOT carry tools or sup- plies in the cab of the truck or on the decks. 35. Adjust the seat and the steering wheel for use. 36.

Read and understand the description of all operator controls. Become familiar with all con- trol locations and functions before operating the truck. 29. Use the stairs and handrails while climbing from the first level to the cab deck. Always mount and dismount ladders facing the truck. Never attempt to mount or dismount while the truck is in motion.