Komatsu — ENGINE START-UP SAFETY PRACTICES

OM3058 Operating Instructions - Section 30 Page 30-5 ENGINE START-UP SAFETY PRACTICES 4. The key switch is a three position (OFF, RUN, START) switch. When the switch is rotated one position clockwise, it is in the RUN position and all electrical circuits (except START) are acti- vated. Never attempt to start the engine by shorting across the cranking motor terminals. This may cause a fire, or serious injury or death to anyone in the machine’s path. a. Turn key switch to the RUN (not START) position. b. With the directional control lever in PARK, rotate the key switch fully clockwise to the START position, and hold this position until the engine starts (see NOTE below).

The START position is spring-loaded and will return to RUN when the key is released. Start the engine from the operator’s seat only. 1. Ensure all personnel are clear of the truck before starting the engine. Always sound the horn as a warning before actuating any opera- tional controls. If the truck is in an enclosure, ensure there is adequate ventilation before start-up. Exhaust fumes are dangerous! NOTE: This truck is equipped with an engine prelube system. With this feature, a noticeable time delay may occur (while engine lube oil passages are being filled and pressurized) before engine cranking will begin. 2. The directional control lever must be in the PARK position before starting. c.

After the engine has started, place the rest switch in the OFF position to enable the drive system. Refer to the discussion on the rest switch in Section 32, Operator Cab Controls. NOTE: The park brake will always be applied whenever the directional control lever is in the park position and the truck is moving slower than 0.5 mph. Move the rest switch to the ON position to put the drive system in rest mode of operation. Refer to discussion of the rest switch in Section 32, Operator Cab Controls. Starting fluid is extremely volatile and flammable! Use with extreme care. 3.

If the truck is equipped with auxiliary cold weather heater system(s), DO NOT attempt to start the engine while the heaters are in opera- tion. Damage to coolant heaters will result! If truck is equipped with optional engine starting aid and ambient temperature is below 10°C (50°F), turn the key switch to the START position, and while cranking the engine, move the engine starting aid switch to the ON position for three seconds MAXI- MUM , then release engine starting aid. If the engine does not start, wait 15 seconds before repeating the procedure. NOTE: The electric cranking motors have a 30 second time limit. If the 30 second limit is reached, cranking will be prohibited for two minutes.

After two minutes, cranking will be allowed. If the 30 second limit is reached seven consecutive times, the key switch must be turned to the OFF position. This will allow the interface module to power down and reset, which requires seven minutes to complete. The cranking motor warning light in the overhead panel will also illuminate if the 30 second time limit or seven attempts is reached.