Komatsu — AFTER ENGINE HAS STARTED

Operating Instructions - Section 30 OM3058 Page 30-6 AFTER ENGINE HAS STARTED 1. Become thoroughly familiar with steering and emergency controls. After the engine has been started, DO NOT accelerate engine speed or drive truck until low pressure and warning sys- tems are normal, and the coolant temperature is at least 71°C (160°F). 4. If any application or release of any brake circuit appears sluggish or improper, or if warning alarms are activated on application or release, shut the engine off and notify maintenance per- sonnel. DO NOT operate the truck until the brake circuit in question is fully operational. 5.

Check the gauges, warning lights and instru- ments before moving the truck to ensure proper system operation and proper instrument func- tioning. Pay special attention to braking and steering circuit hydraulic warning lights. If warn- ing lights come on, shut off the engine immedi- ately and determine the cause. 2. Test the truck steering in extreme right and left directions. If the steering system is not operat- ing properly, shut the engine off immediately. Determine the steering system problem and have it repaired before resuming operation. 3. Operate each of the truck's brake circuits at least twice prior to operating and moving the truck.

These circuits include individual activa- tion from the operator's cab of the service brake, parking brake, and wheel brake lock. With the engine running and with the hydraulic circuit fully charged, activate each circuit indi- vidually. 6. Ensure the headlights, work lights and taillights are in proper working order. Good visibility may prevent an accident. Check operation of the windshield wipers. a. Park the truck on level ground. b. To operate the park brake, place the direc- tional control lever in the PARK position. c. To operate the wheel brake lock, apply the service brake and move directional control lever to neutral. Release service brakes, and apply wheel brake lock.

Turn the wheel brake lock OFF, then back ON again. d. Release wheel brake lock and apply service brakes several times. e. With service brakes applied, move direc- tional control lever to PARK.