Komatsu — MACHINE OPERATION ON THE HAUL ROAD

OM3058 Operating Instructions - Section 30 Page 30-9 3. Check gauges and instruments frequently dur- ing operation for proper readings. 4. Before traveling in reverse, give a back-up sig- nal of three blasts on the horn. Before starting forward, signal with two blasts on the horn. These signals must be given each time the truck is moved forward or backward. 4. Observe all regulations pertaining to the job site's traffic patterns. Be alert to any unusual traffic patterns. Obey the spotter's signals. 5. Match the truck speed to haul road conditions and slow the truck in congested areas. Keep a firm grip on the steering wheel at all times. 5.

Use extreme caution when approaching a haul road intersection. Maintain a safe distance from oncoming vehicles. 6. DO NOT allow the engine to run at idle for extended periods of time. 6. Maintain a safe distance when following another vehicle. Never approach another vehi- cle from the rear, in the same lane, closer than 15 m (50 ft). When driving on a down grade, this distance must not be less than 30 m (100 ft). 7. Check the brake lock performance periodically to ensure safe loading and dumping. 7. DO NOT stop or park on a haul road unless unavoidable.

If the truck must be stopped on a haul road, park in a safe place, move the direc- tional control lever to PARK, and shut the engine off before leaving the cab. Block the wheels securely and notify maintenance per- sonnel for assistance. DO NOT use the brake lock for parking. When the engine is turned off, hydraulic pressure will bleed down, allowing the brakes to release! 8.

While driving on a slope, maintain a speed that will ensure safe driving and provide effective retarding under all conditions (Refer to Dynamic Retarding, in Section 32 Operator Cab Con- trols.) Refer to the grade/speed retard chart in the operator's cab to determine maximum safe truck speeds for descending various grades with a loaded truck. 8. Proceed slowly on rough terrain to avoid deep ruts or large obstacles. Avoid traveling close to soft edges and near the edges of a fill area. 9. Truck operation requires a concentrated effort by the driver. Avoid distractions of any kind while operating the truck. 9.

When operating the truck in darkness, or when visibility is poor, DO NOT move the truck unless all headlights, clearance lights, and tail lights are on. DO NOT back the truck if the back-up horn or lights are inoperative. Always dim the headlights when approaching oncoming vehi- cles. MACHINE OPERATION ON THE HAUL ROAD 1. Always stay alert! If unfamiliar with the haul road, drive with extreme caution. Cab doors must remain closed at all times if the truck is in motion or unattended. 2. Obey all road signs. Keep the truck under con- trol at all times. Govern truck speed by the road conditions, weather and visibility. Report poor haul road conditions immediately.

Muddy or icy roads, pot holes or other obstructions can present hazards. 10. If the emergency steering light and/or low brake pressure warning light illuminate during opera- tion, immediately steer the truck to a safe stop- ping area, away from other traffic if possible. Refer to item 7 above. 11. Check the tires for proper inflation during each shift. If the truck has been operating on a flat or under-inflated tire, the truck must remain out- side of any buildings until the tire cools. 3. Initial propulsion with a loaded truck must begin from a level surface whenever possible. At times, starting on a hill or grade cannot be avoided.

Refer to Starting On A Grade With A Loaded Truck later in this chapter.