Operating Instructions - Section 30 OM3058 Page 30-10 STARTING ON A GRADE WITH A LOADED TRUCK LOADING 1. Approach the loading area with caution. Remain at a safe distance while the truck ahead is being loaded. Initial propulsion with a loaded truck must begin from a level surface whenever possible. There are circum- stances when starting on a hill or grade cannot be avoided. In these instances use the following proce- dure: 2. DO NOT drive over unprotected power cables. 3. When approaching or leaving a loading area, watch for other vehicles and for personnel work- ing in the area. 1. Fully depress the service brake pedal (DO NOT use retarder lever) to hold the truck on the grade.
With the service brakes fully applied, move the directional control lever to a drive position (FORWARD/REVERSE) and increase engine rpm with the throttle pedal. 4. When pulling in under a loader or shovel, follow the spotter’s or the shovel operator’s signals. The truck operator may speed up loading by observing the location and loading cycle of the truck being loaded ahead, and then following a similar pattern. 2. As engine rpm approaches maximum, and when propulsion effort is felt working against the brakes, release the brakes and allow truck movement. Ensure the service brake pedal is completely released.
As truck speed increases above 5-8 kph (3-5 mph) the PSC will drop pro- pulsion if the retarder is still applied. 5. During loading, the operator must stay in the truck cab with the engine running. Place the directional control lever in NEUTRAL and apply the brake lock. 6. When loaded, pull away from the shovel as quickly as possible with extreme caution. NOTE: Releasing and reapplying dynamic retarding during a hill start will result in loss of propulsion. DUMPING PASSING Raising The Dump Body 1. DO NOT pass another truck on a hill or on a blind curve! 1. Approach the dump area with extreme caution. Ensure the area is clear of persons and obstructions, including overhead utility lines.
Obey signals as directed by the spotter, if present. 2. Before passing, ensure the road ahead is clear. If a disabled truck is blocking your lane, slow down and pass with extreme caution. 2. Avoid unstable areas. Keep a safe distance from the edge of the dump area. Position the truck on a solid, level surface before dumping. 3. Use only the areas designated for passing. As the body raises, the truck center of gravity will move. The truck must be on level surface to pre- vent tipping/rolling! 3. Carefully maneuver the truck into the dump position.
When backing the truck into the dump position, use only the brake pedal to stop and hold the truck; DO NOT rely on the brake lock to stop the truck; this control is not modulated and applies the rear service brakes only.