Komatsu — Hookup

OM3058 Operating Instructions - Section 30 Page 30-15 DISABLED TRUCK CONNECTORS 4. If operable brakes are needed on the disabled truck, connect a jumper hose from brake dis- connect coupling (2) to brake disconnect cou- pling (5). GENERAL Refer to the appropriate information in this section of the manual for repair and troubleshooting procedures for the hoist system components and steering system components. Refer to Section J for repair and trou- bleshooting procedures for the hydraulic brake sys- tem components. 5. Start the engine on the good truck and check the operation of the steering and brake system before moving the disabled truck. 6. To disconnect the hoses, stop the engine(s).

Wait two minutes for the hydraulic system to bleed down. Ensure all hydraulic pressure has been relieved before disconnecting the hoses. STEERING AND BRAKE SYSTEM Quick disconnect fittings are provided to allow opera- tion of the steering and brake circuits for temporary truck operation if the steering/brake pump is not operational. To use this feature, two hoses (supply and return) must be connected to a hydraulic source (such as an operational truck or an auxiliary power unit). 7. Ensure the brake system jumper hose is removed when the supply and return hoses are disconnected from the truck. Hookup 1.

When the good truck is in position, stop the engine and wait two minutes to allow the hydraulic system to bleed down. Ensure hydraulic pressure has bled off before connect- ing any hoses. NOTE: Maximum hydraulic pressure is not to exceed 24 304 kPa (3,525 psi). 2. Connect the hydraulic supply hose to the supply disconnect coupling (4, Figure 30-1). NOTE: Failure to attach the return hose from the disabled truck to the hydraulic pressure source could cause the disabled truck hydraulic tank to overflow, or potentially damage the hydraulic power source due to lack of oil. 3. Connect the return hose to the return discon- nect coupling (3). NOTE:

Because there are check valves incorporated into the bleed down manifold, the pressurized fluid supplied by the hydraulic source using supply disconnect coupling (4) will not supply oil to the brake system. To enable brake system operation, a jumper hose must be installed between the brake disconnect fittings (2 & 5). Once the jumper hose is installed, pressurized oil from the hydraulic pressure source will be supplied to both the steering and the brake circuits. FIGURE 30-1. BLEEDDOWN MANIFOLD 1. Bleeddown Manifold 2. Brake Disconnect # 1 3. Return Disconnect 4. Supply/Inlet Disconnect 5. Brake Disconnect # 2 NOTE: The matching quick disconnect couplings for items (2, 4 & 5) is PB4682.

The matching quick disconnect coupling for item (3) is PB4684.